Scytek-electronics G20 Manuel d'utilisateur

VEHICLE SECURITY SYSTEMG25/G20

G25/G20 - Page 9Page 9 - G25/G201. Horn Chirps with Arm & Disarm. Selects one of three modes: Normal, Horn Chirps, and HornChirps w/Warn. Norm

Page 10 - G25/G20Door Lock DiagramsReverse PolarityAdding ActuatorsPositive Horn HonkStarter Interrupt Negative TriggerPositive Triggerbluegreen

© ScyTek Electronics 2011 G25/G20 4-11-09Wiring Diagram Shock SensorGreen - Lock Out (-) 500mABlue - Unlock Out (-) 500mAValet SwitchLEDOrange - Grou

G25/G20 - Page 1PLEASE NOTE:Some of the features described in this manual may require additional parts and/or labor, and may not be includedas part

Remote Transmitter DescriptionThe G25/G20 Security System is supplied with two 5/4-button Remote Transmitters used tocontrol system operations. Butto

G25/G20 - Page 3Tamper AlertIf the system was triggered while away, the LED will flash to indicate which zone triggered thesystem after disarming an

Page 4 - G25/G20Remote ArmingThe system monitors 3 independent areas (zones) while armed: doors, hood/trunk, and shock sensor input.To Arm the System

1. Turn off the ignition.2. Open the door and exit the vehicle.· Once all doors are closed and the dome light is off, the LED will begin flashing ra

10 seconds on the last press.· The system will disarm. If the code is entered incorrectly, turn off the ignition and begin again.To set the Emergency

G25/G20 - Page 7Ignition Controlled Door LocksFor added safety, the Ignition Door Locking feature allows vehicles equipped with power doorlock syste

Page 8 - G25/G20 G25/G20 - Page 8Entering System ProgrammingTo enter System Programming:1. Turn on ignition.2. Within 5 seconds, press the valet sw